Table of Contents
Advertisement
Turning the Interior Light On/Off
Note: The Interior light bulb is not operator replaceable. Notify your Field
Service Engineer to replace the bulb.
The library is normally shipped with the interior light set to the "On"
position. Use the following procedure to turn the interior light "On" or
"Off ."
Refer to Figure -2.
Press the control panel STANDBY button and verify that " System
1
Off-line" is displayed in the SDA.
Press the control panel STOP button.
2
Warning: To prevent injury from moving components, always press
the control panel STOP button before opening the front
door.
Using a 5/32" hex wrench, unlatch the front door.
3
Open the library front door.
4
Note: The front door is the only access for manually turning the interior light
On or Off.
Note: Reach through the front door and set the light switch (located on the
far side of the light) to the desired position.
Close and latch the library front door.
5
Press (to release) the control panel STOP button.
6
Press (to release) the control panel STANDBY button and verify
7
that the library completes the initialization sequence, and "System
On-line" is displayed in the SDA.
ACL 4/52 Facilities Planning and Installation Guide
Appendix B Supplemental Installation Procedures
Turning the Interior Light On/Off
2
43
Advertisement
Table of Contents
