Table of Contents
Advertisement
Chapter 2 Unpacking the Library
Packing the Library for Shipment
Unloading the Library
Installing the Internal
2
Packing Materials
18
2
To unload the library:
1 Remove all tapes from the fixed storage bins.
To do this, grasp the exposed end of each tape and lift it out of the
bin.
2 Remove any tapes in the load port bins.
Load port bins are accessible from inside the library. To remove a
tape from the load port, grasp the exposed end and lift it out.
3 Remove any ejected tapes from the tape drives.
4 If you ejected any tapes prior to turning off the library, they may be
in the drive slots. Remove each tape carefully from the drive; make
sure the tape is completely unloaded (not buckled to the take-up
leader) before completely removing it.
5 For more information, refer to the ACL 4/52 Operator's Guide.
To install the packing materials:
1 Install the foam blocks as shown in figure 12 on page 14 and
explained below:
a
Gently raise the vertical carriage and place the vertical carriage
foam block into position. Lower the vertical carriage onto the
foam block.
b
Install both the top and bottom horizontal carriage foam
blocks.
c
Gently slide the horizontal carriage toward the back of the
library and against the horizontal carriage foam blocks.
2 Install four tie-wraps to secure the extension axis, the vertical
carriage, and the horizontal carriage as shown in figure 11 on
page 13 and explained below:
a
Route the two horizontal carriage tie-wraps through the notch
on the vertical rail and secure them through the notch on the
frame.
b
Route the extension axis tie-wrap around and back up through
the extension axis platform and secure it around the gripper
motor.
Note: Do not route the tie-wrap over the gripper motor power cable.
c
Route the vertical axis tie-wrap under the bumper standoff and
secure it around the extension axis platform.
ACL 4/52 Facilities Planning and Installation Guide
Advertisement
Table of Contents
