Table of Contents
Advertisement
Press the
6
Address, Power-Up State, and Num of Drives menus. Then verify
that the following is displayed in the SDA:
M e n u : C o n f i g u r a t i
A u t o C l e a n . .
With Auto Clean displayed on Line #2 of the SDA, press and
7
release the SELECT button and verify that the following is
displayed in the SDA:
M e n u : A u t o C l e a n
E n a b l e d
Note: "Disabled" is the default. If you want to change the automatic cleaning
state to "Enabled," proceed to Step 8. Otherwise, exit the Menu Mode.
With the desired option displayed on Line #2, press and release the
8
SELECT button.
Press and release the
9
from the command.
Press and release the
10
simultaneously, and verify that System On-line or System Off-Line
is displayed in the SDA.
ACL 4/52 Facilities Planning and Installation Guide
Appendix B Supplemental Installation Procedures
Enabling/Disabling the Auto-Clean Option
button four (4) times to bypass the Inquiry , SCSI
button to clear the resulting display
or
button and the SELECT button
or
35
Advertisement
Table of Contents
