TGB BLADE 425 Service Manual page 40

3. LUBRICATION SYSTEM
Engine Oil
Turn off engine, and park the ATV in flat surface
Check oil level with oil dipstick.
So not screw the dipstick into engine as checking.
If oil level is nearly low level, fill out recommended oil
to upper level.
Oil Change
Drain bolt
Caution
Drain oil as engine warmed up so that makes sure
oil can be drained smoothly and completely.
Place an oil pan under the ATV, and remove oil drain bolt.
After drained, make sure washer can be re-used. Install
oil drain bolt.
Torque value：2.4 kgf-m
Engine Oil Strainer Clean
4 screws
Drain engine oil out.
Remove oil strainer cap.
Clean oil strainer.
Check if O-ring can be re-used.
Install oil strainer cap.
Torque value：1.0~1.2 kgf-m
Engine oil capacity: 3000c.c. when replacing
O-ring
Replace The Oil Filte
r
Same as oil change, drain the oil out.
Remove the oil filter by special tool.
Apply engine oil lightly to the gasket of the new oil filter
when installation.
Torque value：1.2 kgf-m
Oil and filter change:3300c.c. when replacing
Install dipstick, start the engine for running several minutes.
Turn off engine, and check oil level again.
Check if engine oil leaks.
3-3