TGB BLADE 425 Service Manual page 115

FINAL ASSEMBLY
l After adjusting tooth contact correctly, remove the
Front and rear output shafts and drive bevel gear.
l Clean off any dye or paste from the gear teeth, and
lubricate the teeth with engine oil.
l Tighten the drive bevel gear nut and rear out put
Shaft nut to the specified torque.
Rear output shaft nut:100 N．M(10.0 kgf- m, 73 lb-ft)
Drive bevel gear nut:100 N．M(10.0 kgf- m, 73 lb-ft)
l Stake the collar of the nut Ⓐ into the notch in the
shaft.
NOTE:
After the tooth contact have been checked and adjusted
reassemble the joint.
9-9
Final driving mechanism
Ⓐ
Ⓐ