TGB BLADE 425 Service Manual page 113

Final driving mechanism
Apply grease to the oil seal lip.
Install the oil seal to the joint yoke.
(The oil seal lip should be positioned joint yoke side.)
Using a vise hold the driven output rear shaft. Tighten
the new nut to the specified torque.
Torque: 100N-m ( 10kgf-m, 73lb-ft)
Stake the nut with a punch. After The tooth contact and
backlash have been adjusted and checked.
Put the bearing rings and shaft in the crankcase.
Position the bearing pin to the pin grooves in the
crankcase.
Check the gear backlash and tooth contact correctly.
(Tooth face contact 80% up)
Remove the driven output Rear/Front shaft.
Remove the bevel gear.
Clean tooth face.
Tighten the bevel gear nut and output rear shaft to the
specified torque.
Torque: 100N-m( 10kgf-m, 73lb-ft)
Stake the nut with a punch
○
※ should be outside.
The bearing knock-pin
○
※
9-7