TGB BLADE 425 Service Manual page 12

● Do not let the wire harness contact with rotating,
moving or vibrating components as routing the
harness.
● Keep wire harnesses far away from the hot
parts.
● Route wire harnesses to avoid sharp edges or
corners and also avoid the projected ends of
bolts and screws.
● Route harnesses so that they neither pull too
tight nor have excessive slack.
Never too tight
To this chapter contents
Never Touch
1. GENERAL INFORMATION
● Protect wires or wire harnesses with electrical
tape or tube if they contact a sharp edge or
corner. Thoroughly clean the surface where
tape is to be applied.
● Secure the rubber boot firmly as applying it on
wire harness.
● Never use wires or harnesses which insulation
has been broken.
the damaged parts or replace them.
● Never clamp or squeeze the wire harness as
installing other components.
Never clamp or
squeeze the wire
harness
Wrap electrical tape around
1-7