TGB BLADE 425 Service Manual page 132

Crankshaft / crankcase
L CRANK CASE COVER
l Remove the oil pressure valve
When installing the oil valve ,tighten it to the specified
Torque.
Oil pressure value:25N．M(2.5kgf-m,17lb-ft)
Using an shaped tool to check the oil pressure valve
Operation. If the piston does not operate, replace the new
one.
ASSEMBLY
Remove the generator stator.
Remove the oil seal retainer of crank case cover.
NOTE:
If the bearing is not abnormal noise, these is not
necessary to replace the new one.
11-5