TGB BLADE 425 Service Manual page 103

With 4~5g grease spreads wipes drives in the
movable drive face axis hole.
Install drive face boss.
Caution
The movable drive face surface has to be free of
grease. Clean it with cleaning solvent.
Driven pulley installation(By 2 screw)
Press drive belt into pulley groove, and then pull
the belt onto drive shaft.
Install Movable drive face, and nut.
Loosen the 2 screw.
Caution
Make sure that two sides of pulley surfaces have
to be free of grease.
solvent.
Hold drives face with universal holder.
Tighten nut to specified torque.
Torque value: 10~12kgf-m
Install left crankcase cover.
To this chapter contents
Clean it with cleaning
8. V-BELT DRIVING SYSTEM
Press down
Drive face boss
Drive belt
8-9