TGB BLADE 425 Service Manual page 106

8. V-BELT DRIVING SYSTEM
Installation of Clutch OUTER/Driven Pulley
Assembly
Install new oil seal and O-ring onto movable driven
face.
Apply with specified grease to lubricate the inside
of movable driven face.
Install the movable driven face onto driven face.
Install the guide pin and guide pin roller.
Install the collar.
Install friction plate, spring and into clutch spring
compressor, and press down the assembly by
turning manual lever until mounting nut that can be
installed.
Hold the compressor by bench vise and tighten
the mounting nut to specified torque with clutch
nut wrench.
Remove the clutch spring compressor.
Torque value: 5.0~6.0kgf-m
Install driven pulley and drive belt onto drive shaft.
8-12
hs chapter contents
Oil seal
O-ring
Movable driven face
O-ring
Collar
Oil seal
Clutch nut wrench
Clutch spring compressor
Specified grease
Guide pin
Guide pin
Guide pin roller