Table of Contents
Advertisement
Operation
Operating Precautions
Do not exceed the maximum ratings listed below or permanent damage to
the calibrator will result.
Electrostatic discharge
When connecting the U9361C/F/G/M USB cable, always connect the USB-A end of the cable to
the receiver (signal analyzer) BEFORE connecting the USB-C end of the cable to the calibrator
unit.
Avoiding calibrator RF connector damage
See
"Connector Care" on page
Warnings and Cautions
A WARNING notice denotes a hazard. It calls attention to an operating
procedure, practice, or the like that, if not correctly performed or adhered
to, could result in personal injury or death. Do not proceed beyond a
WARNING notice until the indicated conditions are fully understood and
met.
A CAUTION notice denotes a hazard. It calls attention to an operating
procedure, practice, or the like that, if not correctly performed or adhered
to, could result in damage to the product or loss of important data. Do not
proceed beyond a CAUTION notice until the indicated conditions are fully
understood and met.
No operator serviceable parts inside. Refer servicing to qualified
personnel. To prevent electrical shock do not remove covers.
Safety of any system incorporating the equipment is the responsibility of
the assembler of the system.
U9361C/F/G/M Receiver Calibrator Quick Start Guide
24.
Operation
11
Advertisement
Table of Contents
