Verifying Basic Oscilloscope Operation - Keysight Technologies Z Series User Manual

Verifying Basic Oscilloscope Operation

1
2
3
Aux Out Cal Out
Figure 6

Verifying Basic Oscilloscope Operation

4
5
Infiniium Z-Series Oscilloscopes User's Guide
Install the supplied connector savers to each channel input. Keysight
recommends using the connector savers to protect the input connectors.
Connect one end of the 54916-61626 calibration cable to oscilloscope input
channel 1.
Connect the other end of the calibration cable to the Cal Out connector on the
front panel.
Digital Storage Oscilloscope
DSO-X 96204Q DSO-Z 204A DSO-Z 204A Z-Series Z-Series Digital Storage Oscilloscope Digital Storage Oscilloscope
Calibration Cable (54916-61626)
Press [Default Setup] on the front panel.
The display will pause momentarily while the oscilloscope is configured to its
default settings.
Press [Auto Scale] on the front panel.
The display will pause momentarily while the oscilloscope adjusts the time/div
setting and vertical scale. You should then see a square wave with about four
cycles on screen and a peak-to-peak amplitude of approximately five divisions.
62 GHz 160 GSa/s 20 GHz 20 GHz 80 GSa/s 80 GSa/s
Run Control
Run
Stop
Horizontal
Push
for Vernier
Zoom
Auto Clear
Touch
Scale Display
Trigger
Aux
Source Slope Sweep
Measure
Print Multi
Screen Purpose
Short
Markers
Position Cut
(Push to Toggle)
(Hold to Reset)
Vertical
1
Push
for Vernier
2
3
Push
for Vernier
4
1R RealEdge
Setting Up the Oscilloscope
Single
Push
to Zero
Default
Setup
Level
(Push for 50%)
Menu
Touch Turn
Push
to Zero
Push
to Zero
3R
1
21