Table of Contents
Advertisement
Care and Maintenance
Applying Torque
For the 1 mm Output Port connector, use the dual torque wrench. For matching non-ruggedized
connectors using the inner threads, to the U9361M, use the 4 lb-in torque wrench.
Two wrenches must be used to avoid stress on semi-rigid cables.
Figure 8
Wrenches on Test Port
Handle fully broken
(not recommended)
The silver end of the dual torque wrench is 4 lb-in. The red end of the
torque wrench is 10 lb-in.
30
Direction to
tighten connection
U9361C/F/G/M Receiver Calibrator Quick Start Guide
Groove marks
the correct place
to hold wrench
Handle begins to break
(correct point to stop)
< 90°
Do not turn
Advertisement
Table of Contents
