2
Initial Setup
Verifying Basic Oscilloscope Operation
If you have a 6000L Series oscilloscope, you need to start a Web control session,
as described in
1 Press the [Save/Recall] key on the front panel, then press the Default Setup
2 Connect an oscilloscope probe from channel 1 to the Probe Comp terminal on
3 Connect the probe's ground lead to the ground terminal (next to the Probe Comp
4 Press [AutoScale].
5 You should see a waveform on the oscilloscope's display similar to this:
If you see the waveform, but the square wave is not shaped correctly as shown
above, perform the procedure
If you do not see the waveform, ensure your power source is adequate, the
oscilloscope is powered-on, the power cord is firmly inserted into the oscilloscope
receptacle, and the probe is connected securely to the front-panel oscilloscope
channel input BNC and to the Probe Comp terminal.
38
"Accessing the Web Interface"
softkey ([Save/Recall]&Default Setup). The oscilloscope is now configured to its
default settings (configuration details on
the front panel.
terminal).
on page 281.
page
"Compensating Passive Probes"
Keysight InfiniiVision 6000L Series Oscilloscopes User's Guide
388).
on page 66.