Table of Contents
Advertisement
Chapter 9: Using the External State Analyzer
Configuring the External Analyzer
To control the external analyzer with the
emulator/analyzer interface
1 Enter the modify configuration command.
2 Answer "yes" to the "Modify external analyzer configuration?" question.
3 Answer the "Should emulation control the external bits?" question.
Answer "yes" if the emulation emulator/analyzer interface should control the
external analyzer. You must answer "yes" to access the remaining external
analyzer configuration questions. At the end of the configuration process the
external analyzer mode and threshold voltages will be set; existing labels will be
deleted, and only the labels specified in response to the questions below will be
defined.
Answer "no" if the emulation emulator/analyzer interface shouldn't control the
external analyzer. If emulation does not control the external bits, the external
analyzer configuration will not be modified in any way by the emulation interface.
274
Advertisement
Table of Contents
