End - HP 64767 User Manual

end

This command terminates the current emulation session.
You can end the emulation session and keep the emulator in a locked state. The
current emulation configuration is stored, so that you can continue the emulation
session on reentry to the emulator. You also can release the emulation system when
ending the session so that others may use the emulator.
Note that pressing <CTRL>d performs the same operation as pressing end
<RETURN>. Pressing <CTRL>\ or <CTRL>| performs the same as end
release_system <RETURN>.
When the emulation session ends, control returns to the UNIX shell without
releasing the emulator.
The parameters are as follows:
locked
This option allows you to stop all active instances of an emulator/analyzer interface
session in one or more windows and/or terminals. This option is not available
when operating the emulator in the measurement system.
release_system
This option stops all instances of the emulator/analyzer interface in one or more
windows or terminals. The emulation system is released for other users. If you do
not release the emulation system when ending, others cannot access it.
Examples
end <RETURN>
end release_system <RETURN>
See Also
The "Exiting the Emulator/Analyzer Interface" section in the "Starting and Exiting
HP 64700 Interfaces" chapter.
Chapter 12: Emulator/Analyzer Interface Commands
end
363