To Use A Custom Foreground Monitor Program - HP 64767 User Manual

Chapter 5: Configuring the Emulator
Selecting the Emulation Monitor Program

To use a custom foreground monitor program

1 Answer "user_foreground" to the "Monitor type?" question.
2 Answer "yes" to the "Reset map (change of monitor type requires map reset)?"
question.
3 Enter the segment portion of the monitor program's base address in response to the
"Monitor segment?" question.
4 Enter the offset portion of the monitor program's base address in response to the
"Monitor offset?" question.
5 Answer "yes" or "no" to the "Lock Foreground Monitor memory to target?"
question.
6 Enter the name of the monitor program absolute file in response to the "Monitor
filename?" question.
7 Re-map memory (see the following section on "Mapping Memory").
When customizing the foreground monitor, you must maintain the basic
communication protocol between the monitor program and the emulation system
controller. Comments in the monitor program source file detail sections that cannot
be changed.
The foreground monitor program is supplied with the interface software and can be
found in the following location:
$HP64000/monitor/fmonI186XL.s
A custom foreground monitor is downloaded when the configuration is applied to
the emulator. The custom foreground monitor is saved in the emulator (until the
monitor type is changed) and reloaded every time the emulator breaks into the
monitor state from the reset state.
120