Table of Contents
Advertisement
Chapter 13: Error Messages
Graphical/Softkey Interface Messages - Unnumbered
Illegal status combination
Cause: You tried to specify combinations of status qualifiers in expressions
incorrectly when entering commands.
Action: Refer to the "Emulator/Analyzer Interface Commands" chapter for
information about syntax of commands.
Illegal symbol name
Cause: You tried to specify incorrect symbol names when entering commands.
Action: Specify correct symbol names. To see global symbol names, use the
display global_symbols command. To see local symbol names, use the
display local_symbols_in <SYMB> command.
Initialization failed
Cause: The emulator could not be initialized.
Action: Make sure your data communication switch settings are correct, and that all
Softkey Interface software has been loaded properly. Cycle power on the emulator,
then try starting up the emulation session again.
Initialization load failed
Cause: The emulator could not be initialized.
Action: Make sure your data communication switch settings are correct, and that all
Softkey Interface software has been loaded properly. Cycle power on the emulator,
then try starting up the emulation session again.
Initializing emulator with default configuration
Cause: This is a status message. The host system started the emulation session and
initialized the emulator using the default configuration. The emulator is probably
operating correctly.
Initializing user interface with default config file
Cause: This is a status message. The host system started the emulation session and
Softkey Interface using the default configuration file. The emulator is probably
operating correctly.
442
Advertisement
Table of Contents
