HP 64767 User Manual page 464

Chapter 13: Error Messages
Terminal Interface Messages
622 %s
Cause: Monitor specific message.
623 CMB execute break
Cause: This message occurs when coordinated measurements are enabled and an
EXECUTE pulse causes the emulator to run; the emulator must break before
running.
Action: This is a status message; no action is required.
624
Configuration aborted
Cause: Occurs when a <CTRL>c is entered while emulator configuration items are
being set.
626
Configuration failed; setting unknown: %s=%s
Cause: Target condition or system failure.
Action: Check target system, and run performance verification (Terminal Interface
pv command).
628 Guarded memory break: %s"
Cause: A memory access to a location mapped as guarded memory has occurred
during execution of the user program.
Action: Investigate the cause of the guarded memory access by the user program.
628
Write to ROM break: %s"
Cause: When the emulator is configured to break on writes to ROM, a memory
write access to a location mapped as ROM has occurred during execution of the
user program.
Action: Investigate the cause of the write to ROM by the user program. You can
configure the emulator so that it does not break on writes to ROM.
630 Register access aborted
Cause: Occurs when a <CTRL>c is entered during register display.
464