HP 64767 User Manual page 459

Action: The ROMs in your emulator must be compatible with each other for your
emulation system to work correctly. Contact your Hewlett-Packard Representative.
312
Ambiguous address: %s
Cause: Certain emulators support segmentation or function code information in
addressing. The emulator is unable to determine which of two or more address
ranges you are referring to, based upon the information you entered.
Action: Re-enter the command and fully specify the address, including
segmentation or function code information.
318 Count out of bounds: %s
Cause: You specified an occurrence count less than 1 or greater than 65535.
Action: Re-enter the command, specifying a count value from 1 to 65535.
400 Record checksum failure
Cause: During a transfer operation, the checksum specified in a file did not agree
with that calculated by the HP 64700.
Action: Retry the transfer operation. If the failure is repeated, make sure that both
your host and the HP 64700 data communications parameters are configured
correctly.
401 Records expected: %s; records received: %s
Cause: The HP 64700 received a different number of records than it expected to
receive during a transfer operation.
Action: Retry the transfer. If the failure is repeated, make sure that the data
communications parameters are set correctly on the host and on the HP 64700.
410 File transfer aborted
Cause: A transfer operation was aborted due to a break received, most likely a
<CTRL>c from the keyboard.
Action: If you typed <CTRL>c, you probably did so because you thought the
transfer was about to fail. Retry the transfer, making sure to use the correct
command options. If you are unsuccessful, make sure that the data
Chapter 13: Error Messages
Terminal Interface Messages
459