HP 64767 User Manual page 451

Chapter 13: Error Messages
Graphical/Softkey Interface Messages - Unnumbered
Unexpected message from emul700dmn
Cause: The host system could not start the emulation session because of an
unexpected message from the HP 64700 emulator process command.
Action: You must press end_release_system to exit this emulation session
completely; then start a new session. Make sure the host system is operating
properly, that all Softkey Interface software has been loaded correctly, and the data
communication switch settings on the emulator rear panel match the settings in the
/usr/hp64000/etc/64700tab.net (or 64700tab) file.
Unknown expression type
Cause: While entering your command, you included an unknown expression type.
Action: See the EXPR command syntax for more information about expressions.
Then try entering your command again with a known expression type.
Unload trace data failed
Cause: An unexpected error occurred while waiting for a trace to be completed.
Action: End and release the session, and then try again.
Wait time failure, could not determine system time
Cause: The system call failed.
Action: Verify that 'date' executes correctly from the UNIX prompt.
Warning: at least one integer truncated to 32 bits
Warning: at least one integer truncated to 16 bits
Warning: at least one integer truncated to 8 bits
Cause: The number entered was too large for the currently specified display or
access size.
Action: Try entering the command again using the correct size of number.
Width not in range: 1 <= valid width <= 80
Cause: You tried to specify the width of the field outside the range from 1 to 80.
Action: Try entering the command again using a valid number for the width.
451