Table of Contents
Advertisement
Chapter 1: Getting Started
Step 10: Trace the program
Notice that now the message on the status line is "Emulation trace complete". This
shows the trigger state has been found and the analyzer trace memory has been
filled.
5 To view the captured states, choose Display→Trace.
Or, using the command line, enter:
display trace <RETURN>
The default display mode settings cause source lines and symbols to appear in the
trace list.
Captured states are numbered in the left-hand column of the trace list. Line 0
always contains the state that caused the analyzer to trigger.
Other columns contain address information, data values, opcode or status
information, and time count information.
42
Advertisement
Table of Contents
