Table of Contents
Advertisement
seconds
This causes the system to pause for a specific number of seconds.
<TIME>
This prompts you for the number of seconds to insert for the delay.
Note that a wait command in a command file will cause execution of the command
file to pause until a <CTRL>c signal is received, if <CTRL>c is defined as the
interrupt signal. Subsequent commands in the command file will not execute while
the command file is paused. You can verify whether the interrupt signal is defined
as <CTRL>c by typing set at the system prompt.
Examples
wait <RETURN>
wait 5; wait measurement_complete <RETURN>
Chapter 12: Emulator/Analyzer Interface Commands
wait
429
Advertisement
Table of Contents
