HP 64767 User Manual page 449

Chapter 13: Error Messages
Graphical/Softkey Interface Messages - Unnumbered
Action: Find the window that caused the error and see the error message that it
displayed. All the additional windows will simply state "session aborted". Cycle
power on the emulator and enter emul700 -u <logical name> to make sure the
emulator is unlocked.
Session cannot be continued, ending released
Cause: The emulation session is ending automatically because it could not be
continued from the previous session. When the session has ended the emulator will
be released, meaning that others can access and use it.
Action: When you restart the emulation session later, the new session will use all
default settings.
Slave clock requires at least one edge
Cause: The analyzer has an invalid clock specification.
Action: Modify your configuration and try your command again.
Starting address greater than ending address
Cause: You specified a starting address that is greater than the ending address.
Action: Specify a starting address that is less than or equal to the ending address.
Starting new session, continue file loaded
Cause: This is a status message. The emulator was started using a new emulation
session, and the continue file loaded properly.
Starting new session, user interface defaulted
Cause: The emulator was started using a new emulation session, and the user
interface was set to default selections.
Action: Call your HP Service Representative.
Status unknown, run "emul700 -l <LOGICAL NAME>"
Cause: The host system cannot determine the status of the emulator.
Action: To verify communication between the emulator and the host system, and
display the emulator status, enter the emul700 -l <logical name> command. The
449