Connecting To An Mcu - Polycom MGC+100 Release Note

MGC Release Notes - Version 7.5

Connecting to an MCU

Before running the diagnostic tests on an MCU, you must connect the MCU to the Falcon
diagnostic tool.
To connect the Falcon diagnostic tool to a specific MCU:
1.
2.
You must close all On Going Conferences before opening the Falcon diagnostic
tool. If a conference is running when you try to connect to an MCU, an error
message is displayed indicating that you must first close the On Going
Conference.
When the Falcon diagnostic tool resets the MCU, it identifies the MCU cards that can be
tested. Cards that cannot be tested are displayed in the MGC Manager but not in the Falcon
tool.
74
Double-click on the selected MCU icon or right-click on the MCU icon and click
Connect from the right mouse menu or the Main menu options.
A message appears indicating that the MCU must be reset in the Falcon mode.
Click OK.