Connecting To The Mcu - Polycom Real-Time Media Conferencing Platform RMX 2000 Installation & Configuration Manual

Initial RMX Configuration
The system is shipped with the following default IP addresses:
• Control unit IP address – 192.168.1.254
• Control unit subnet mask – 255.255.255.0
• Control unit default gateway – 192.168.1.1
When the RMX is installed for the first time, you must change the
default IP addresses to your local network settings. This can be done by
modifying the default settings in the USB key shipped with the unit and
uploading them to the RMX.
1
Plug the USB key into a PC.
2 Use a text editor application to open the
USB key.
3 In the file, define the Management (Control Unit) IP
LAN.CFG
address, subnet Mask and Default gateway parameters and the
Shelf Management (switch) IP Address as allocated by the network
administrator. Make sure that there are no extra spaces at the end of
each line.
4
Save the
LAN.CFG
5
Insert the USB key with the modified IP addresses in the USB port
on the back panel.
6
Power the RMX on.
The parameters are uploaded from the USB key to the RMX. Power
up is complete when the red HD active LED starts blinking.
7
Remove the USB key.

Connecting to the MCU

1
Start the RMX Web Client application on the workstation, by
entering
http://<Control Unit IP Address>
USB key in your browser's address line and pressing Enter.
2
Enter your Login Name and Password, and then click OK.
The default Login Name and Password are both POLYCOM.
file.
file stored on the
LAN.CFG
as defined in the
3