Version 7.5 - New Features List - Polycom MGC+100 Release Note

Version 7.5 - New Features List

The following table lists the new features in Version 7.5.
Table 1: New Features List
Category
Video
1.
2. Video
3. Video
Video
4.
Video
5.
6. IP
IP
7.
Feature Name
H.264 SD/HD in Video
Switching conferences
Increased Frame Rate in
H.264 CP conferences
H.264 up to 2 Mbps in
VideoSwitching
Conferences
H.264 Fixed Mode
Video Support for Start
Conference requires
Chairperson
H.323 dial-out automatic
redial
Direct IP Dial-in
Version 7.5 - New Features List
Description
H.264 Standard Definition (SD), High
Definition (HD) and VSX 8000 (version
8.0) HRR resolutions are supported in
Video Switching conferences.
Set the system.cfg flag:
ENABLE_HD_SD_IN_FIXED_MODE=
YES (default =NO). When YES, the
Highest Common mode is enabled.
Higher Frame rates in H.264 CP
conferences. The MCU now supports
frame rates up to 30 FPS in CP
conferences.
In H.264 VideoSwitching Conferences,
the maximum Line Rate capability is
1920 Kbps.
Supported in MGC version 7.03.
H.264 Fixed mode can be used with
cascaded conferences by setting the
H.264_VSW_AUTO flag to YES. These
flag settings forces all endpoints to use
predefined conference resolution and
frame rates.
This feature is now available for video
conferences.
When the conference is set to Wait for
Chairperson and participants connect to
the conference before the chairperson,
the conference is placed on hold.
When an H.323 dial-out call fails to
connect because the endpoint could not
be reached (for example, the endpoint is
busy), the system can be set to
automatically redial the endpoint.
Set the system.cfg flag:
ENABLE_H323_REDIAL=YES.
The MCU supports two new IP Dial-in
methods:
•
Direct Endpoint Dialing (Without
Gatekeeper)
• IP to ISDN Gateway Call (without
Gatekeeper)
1