Polycom MGC+100 Release Note page 68

MGC Release Notes - Version 7.5
Table 7: System Limitations (Continued)
No.
92.
93.
94.
95.
96.
97.
98.
99.
100.
101.
64
Category Description
Video When resetting the video units quickly
(one after the other), the video card
status changes to Major.
Video Video force settings are not saved after
interactively (Drag & Drop) moving a
participant from an Operator
conference to the Home conference.
Video On QCIF endpoints the supported
layouts are up to 3x3 only (not 4x4 for
instance).
Video When moving an endpoint that
Switching supports H.261, H.263 and H.264 from
a Video Switching conference set to
H.261 to a Video Switching conference
set to H.263 or H.264 it connects as
Secondary. When disconnecting and
reconnecting the endpoint it still
connects as Secondary.
Video When an FX endpoint connects to a
Switching conference set to 4CIF & 15 fps and if
the conference video format changes
to CIF or QCIF, the MCU connects the
endpoint at 15 fps, although it should
have connected the endpoint at 30 fps.
Video A Video Switching conference
Switching reservation with 4CIF Video Format
and 15 fps Frame rate settings, the
conference starts with CIF - 30 fps
settings.
Video+ When changing the default layouts for
Auto Layout in the confer.cfg file, the
Auto Layout is activated only after the
fourth participant connects to the
conference.
Video+ Up to 128 participants can be
connected to a single Video+ card.
Video+ During a video conference with XGA
Content, when there is a speaker
switch, a delay of 6-10 seconds occurs
before the video feed changes to the
new speaker.
VTX1000 The VTX1000 check box function
included with MGC Manager version
7.5, will only be available in later
versions.
Workaround/
ID#
Remarks
— Wait a few seconds
for the board to
change to Normal,
and then reset the
next unit.
3838
18421
6947
and
16869
13979
18479
—
—
19333