Control Unit Update Notice - Polycom MGC+100 Release Note

*1—These cards are not supported with the MGC+50/100. Only Audio+12/24, Audio+24/48 and
*2—Does not work with the new IP+ card V4.43 (IP+12/24/48)
*3—Backward compatible; shipped with IP+ V4.43 (MGC 7.0.0)
Please be aware that upgrading the MGC-100 hardware may require upgrading the power
supplies (the MGC-50 has one 600W power supply). As a general guideline:
•
•
•
•
•

Control Unit Update Notice

The MCU Control unit must have at least 128 MB of memory to run MCU Version 7.5 and
later.
# Board Type
18. MUX+20
MUX+40
19.
MGC-25
20. IPN
21. IPN
22. AUDIO-A
AUDIO-A
23.
Audio+48/96 are supported with the MGC+50/100.
Each board consumes up to 40W apart from video boards.
The Video+8 board consumes 75W, the Video6 board (older video board) consumes
55W and the Dual Video (2 Video6 boards tied together) consumes 110W.
The Control Unit consumes 30W.
Each older power supply unit (marked as PWR on its front panel) provides 300W (AC
& DC).
Each new power supply unit (marked as POWER on its front panel) provides 450W
(AC & DC).
H/W
MGC Versions
Version
V4.43 V7.0 and later
V4.44 V7.0 and later
V1.24 & V5.0 and later
V1.26
V1.41 V6.11, V7.0 and
later
V1.04 V5.0 and later
V1.21 V6.11, V7.0.1
and later
Prior to Installation and SW Upgrade
SIP H.264 H.239
n/a n/a n/a
n/a n/a n/a
YES YES YES
YES YES YES
YES YES YES
YES YES YES
AES
YES
YES
YES
YES
YES
YES
7