Connecting The Power And Cables; Administration Of The 4350 - Polycom V2IU 4350 User Manual

2
User Manual V IU 4350 Converged Network Appliance

Connecting the Power and Cables

Warning
Caution

Administration of the 4350

2 - 4
The 4350 comes with an AC power cord and power adapter for connecting the
unit to the AC outlet.
Always connect the AC power cord to an AC outlet suitable for the power supply
that came with the unit in order to reduce the risk of damage to it.
• Connect one end of the AC power cord to the power adapter and the other one
to the AC outlet.
• Connect plug from the power adapter to the Power Connector on the 4350.
Sometimes a little force is necessary to get the plug properly positioned
Secure the power adapter using a fastener or tie wrap to nearby shelf so that it
does not hang from the power connector.
If you are connecting to the WAN using the T1, then connect the T1 cable to
the T1/E1 port and the other end of the cable to the T1 line. Enable the T1 port
from the Network Configuration Menu. In this case, the Ethernet WAN port
will not be available.
If you are connecting to a WAN router, cable modem or DSL modem, then
connect the Ethernet cable to the Ethernet WAN port on 4350 and the other end
to the WAN device.
The 4350 is configured using a web browser such as Internet Explorer or
Netscape Navigator. The 4350 is shipped with a pre-configured IP address for
its LAN port of 192.168.1.1. To connect to the 4350, do the following:
1. Connect a PC using an IP address of 192.168.1.2 and subnet mask of
255.255.255.0 to LAN port 4 of the 4350.