Disconnecting From The Falcon Diagnostic Tool - Polycom MGC+100 Release Note

MGC Release Notes - Version 7.5

Disconnecting from the Falcon Diagnostic Tool

Disconnecting from the Falcon diagnostic tool resets the MCU and puts it back into Normal
mode. If the MCU is not connecting properly in the MGC Manager Application, this option
is a good way to restore the connection. This is also the recommended way to close the
Falcon tool.
To disconnect from the Falcon diagnostic tool:
1.
2.
80
Right-click the MCU icon and then select Disconnect. Alternatively, on the MCU
menu, click Disconnect.
A pop-up window appears prompting you to confirm the selection.
Click OK.
The MCU disconnects from the Falcon diagnostic tool and is reset. At the end of the
reset, the MCU status is restored to Normal mode.