Install The Field Computer - Raven RS1 Installation Manual

Chapter 4
2. Use the base plate of the foot switch as a template to drill holes for mounting the foot
switch.
3. Secure the foot switch to the floor using the supplied screws through the base plate.

Install the Field Computer

Several options exist for compatible displays for field computers for the DirecSteer system.
The following instructions are general recommendations when mounting a field computer.
1. Loosen the RAM® socket arm and remove the circular base or pipe clamp.
2. Mount the circular base to a flat surface or to the u-bolt pipe clamp within the
operator's cabin or compartment.
3. Place the square base over the mounting posts on the back of the console.
Note: The ball on the square base is offset to provide additional clearance or mobility
of the console. The base may be oriented with the ball toward either the top or bottom
of the console as necessary or desired for the selected mounting position.
4. Use the provided flat washers, lock washers and screws to secure the square base to
the back of the console.
5. Replace the RAM® socket arm onto the circular base or u-bolt pipe clamp and tighten
the arm to secure the console.
6. Adjust the console as necessary for optimal viewing and operation.
Note: It is normal for the display case to become warm to the touch during operation.
32