Raven RS1 Installation Manual page 47

With direcsteer

Hide thumbs Also See for RS1:

Table of Contents

If Installing a Kit with IBBC:

a. Starting from the battery, route the implement ready power harness (P/N 115-

8000-060/315) through the machine so the IBBC connectors end up near the

back of the machine.

b. Ensure the 12-pin connector can still be routed into the cab of the machine.

c. At the back of the machine, find the most appropriate mounting position for the

IBBC connector. Be careful to consider moving parts or clinch points.

d. Use the supplied tools to attach the IBBC connector (P/N 408-4002-131) to the

mounting plate.

e. Mount the IBBC plate and connector to the back of the machine.

f. Connect the ISObus IBBC connector from the DirecSteer power harness (P/N

115-8000-060/315) to mounted IBBC connector.

If Installing a Kit without IBBC:

a. Starting from the battery, route the basic power harness (P/N 115-8000-141) to a

point in the machine where the 12-pin connector cable can enter the cabin.

Install RS1™ with DirecSteer

Table of Contents

Sc1