Raven RS1 Installation Manual page 29

With direcsteer

Hide thumbs Also See for RS1:

Table of Contents

4. Position the provided template (P/N 107-4050-149) inside the cover as shown below.

Note:

Line hole A (larger) with the existing hole in the cover.

5. Use the template to mark hole B (smaller) on the cover.

6. Use a step-bit to drill a 25 mm hole in the trim piece at the marked location.

Note:

Ensure the 19mm spacer (P/N 107-4050-145) fits through hole B drilled in the

cover.

7. Install the cover and secure with only the two screws on either side.

Install the DirecSteer System

Table of Contents

Sc1