Toyota Prius 2010 Repair Manual page 315

8. CONNECT DISCHARGE HOSE SUB-ASSEMBLY
(a) Remove the attached vinyl tape from the hose and the connecting part of the cooler condenser assembly.
(b) Sufficiently apply compressor oil to a new O-ring and the fitting surface of the hose joint.
Compressor oil:
ND-OIL 11 or equivalent
(c) Install the O-ring on the discharge hose sub-assembly.
NOTICE:
Keep the O-ring and O-ring fitting surfaces clean from dirt or any foreign objects.
Do not use any compressor oil other than ND-OIL 11 or equivalent. If any compressor oil other than
ND-OIL 11 or equivalent is used, compressor motor insulation performance may decrease, resulting in a
leakage of electric power.
9. INSTALL MILLIMETER WAVE RADAR SENSOR BRACKET
(a) w/o Dynamic Radar Cruise Control System:
(b) w/ Dynamic Radar Cruise Control System:
2010 Toyota Prius
(d) Install the discharge hose sub-assembly on the cooler condenser
assembly with the bolt.
Torque: 5.4 N·m (55 kgf·cm, 48in·lbf)
(1) Install the millimeter wave radar sensor bracket with the 3 bolts.
Torque: 6.2 N·m (63 kgf·cm, 55in·lbf)
NOTICE:
Tighten the bolts in the order shown in the illustration to install the
millimeter wave radar sensor bracket.
Repair Manual