Toyota Prius 2010 Repair Manual page 153

OK:
The display is as specified in the Normal Condition column.
Result:
NG
OK (When troubleshooting according to Problem Symptoms Table)
OK (When troubleshooting according to the DTC)
C
REPLACE A/C AMPLIFIER
B
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE
A
2. CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT)
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection
I1-3 (CLTB) - I1-6 (CLTE)
I1-3 (CLTB) - I1-6 (CLTE)
Text in Illustration
Front view of wire harness connector
*1
(to Solar Sensor (Automatic Light Control Sensor))
2010 Toyota Prius
Result
(a) Disconnect the solar sensor (automatic light control sensor) connector.
Condition
Power switch off
Power switch on (IG)
Proceed to
A
B
C
Specified Condition
Below 1 V
11 to 14 V
Repair Manual