Toyota Prius 2010 Repair Manual page 297

(d) Connect the connector <B>.
3. CONNECT SUCTION HOSE SUB-ASSEMBLY
(a) Remove the attached vinyl tape from the hose.
(b) Sufficiently apply compressor oil to a new O-ring and the fitting surface of the compressor and magnetic
clutch.
Compressor oil:
ND-OIL 11 or equivalent
(c) Install the O-ring onto the suction hose sub-assembly.
NOTICE:
Keep the O-ring and O-ring fitting surfaces free from dirt or any foreign objects.
Do not use any compressor oil other than ND-OIL 11 or equivalent. If any compressor oil other than
ND-OIL 11 or equivalent is used, compressor motor insulation performance may decrease, resulting in a
leakage of electric power.
2010 Toyota Prius
electric inverter compressor.
(c) Connect the connector <A> and lock the green-colored lock as shown
in the illustration.
CAUTION:
Wear insulated gloves when performing the procedures.
Text in Illustration
*1 Green-colored Lock
(d) Install the suction hose sub-assembly onto the compressor and
magnetic clutch with the bolt.
Torque: 9.8 N·m (100 kgf·cm, 87in·lbf)
Repair Manual