Toyota Prius 2010 Repair Manual page 119

CAUTION:
Be sure to wear insulated gloves.
NG
REPLACE NO. 2 ENGINE WIRE
OK
REPLACE COMPRESSOR WITH MOTOR ASSEMBLY
2010 Toyota Prius
(a) Disconnect the No. 2 engine wire connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
E1-1 (PE) - E2-2 (ACPE)
E1-2 (PB) - E2-1 (ACPB)
E1-1 (PE) - Body ground
E1-2 (PB) - Body ground
Text in Illustration
Front view of wire harness connector
*1
(to Compressor with Motor Assembly)
Front view of wire harness connector
*2
(to Inverter with Converter Assembly)
Condition Specified Condition
Always Below 1 Ω
Always Below 1 Ω
Always 10 kΩ or higher
Always 10 kΩ or higher
Repair Manual