Toyota Prius 2010 Repair Manual page 13

INSTALLATION
1. INSTALL AIR CONDITIONING PRESSURE SENSOR
(b) Install the new air conditioning pressure sensor.
Torque: 11 N·m (110 kgf·cm, 8ft·lbf)
NOTICE:
Do not deform the piping.
Make sure to confirm that the piping does not disengage from the plastic clamp.
(c) Connect the connector.
2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected
3. INSTALL REAR NO. 3 FLOOR BOARD
4. INSTALL REAR DECK FLOOR BOX
5. INSTALL REAR NO. 2 FLOOR BOARD (for Separate Type)
6. CHARGE WITH REFRIGERANT
7. WARM UP COMPRESSOR
8. INSPECT FOR REFRIGERANT LEAK
2010 Toyota Prius
(a) Sufficiently apply compressor oil to a new air conditioning pressure
sensor.
Compressor oil:
ND-OIL 11 or equivalent
Keep the O-ring and O-ring fitting surfaces clean from dirt or any
foreign objects.
Do not use any compressor oil other than ND-OIL 11 or
equivalent. If any compressor oil other than ND-OIL 11 or
equivalent is used, compressor motor insulation performance may
decrease, resulting in a leakage of electric power.
.
Repair Manual