Nortel Communication Server 1000 Series Manual page 91

From the report find unused superloops, which can be used for the Fiber
Remote Multi-IPE Interface application.
To change the system configuration record and to configure the Peripheral
Controller card at the Remote IPE site, load Configuration Record Program
LD 17 and Configuration Record Program LD 97.
After the new Peripheral Controller is defined, define the superloop for the
Superloop Network card designated to support the Remote IPE.
Copyright © 2007-2009 Nortel Networks
.
Table 17
CFN configuration data print format- find unused superloop
CEQU
MPED SD DD 4D
8D
xxx xxx xxx...
TERM
xxx xxx xxx...
REMO
xxx xxx xxx...
SUPL
Table 18
To change the system configuration record (LD 17)
Prompt Response
REQ CHG
TYPE CFN
CEQU YES
MPED 8D
Table 19
To configure the Remote IPE site (LD 97)
REQ CHG
TYPE XPE
XPEC 2
LOC SCLARA
MED
RGTP (8) 16
Nortel Communication Server 1000
Fiber Remote Multi-IPE Interface Fundamentals
NN43021-556 03.01
11 May 2009
Configuring the equipment 91
Prints maximum peripheral density for the
system (use 8D for systems with IPE)
Prints all terminal loops
Prints remote EPE loop numbers configured in
LD 17
Lists all local Superloop Network card superloop
numbers
Description
Change the configuration record
Configuration record
Change equipment
Peripheral density
Change definition
Remote Peripheral Controller ID
Card position
Remote site location example. Use any 6
alphanumeric characters to identify the remote
site
Default number of concurrent ringers. Change to
a maximum of16 ringers capacity for all ringers
except the old DC version