Nortel Communication Server 1000 Series Manual page 135

Procedure 42
Checking the superloop and the fiber-optic link status
Step
To obtain the superloop and link status:
1
2
Copyright © 2007-2009 Nortel Networks
.
The log file contains 30 days of error statistics. During each
midnight routine, the file stores the highest error rate minute
detected in the last 24 hours and the time and date when it
occurred. If the redundant link is present, the error statistics of
both links is displayed. The response is displayed on the screen
as follows:
Example:
FII::>D E
Fiber Remote IPE S/N 2502 Software Version 3.11
5/15/96 10:45
Local Site
In Alarm State: NO (superloops are not in the alarm
state)
Clear the near-end (local) error log by executing the C E (CLEAR
ERROR) and the far-end (remote) by executing the C E D
(CLEAR ERROR DISTANT) command.
This procedure uses MMI commands to display the
superloop and the fiber-optic link status.
Action
Log in on the MMI maintenance terminal:
FII:: >L
Enter Password > FIBER
Type D S (DISPLAY STATUS) to display near-end superloop and
fiber-optic link status.
Type D S D (DISPLAY STATUS DISTANT) to display far-end
status.
The response is displayed on the screen and shows the software
version, present time and date, alarm status, error rate, and the
superloop link status.
Example:
FII::>D S
Fiber Remote IPE S/N 25002-R3 Software Version 2.05
04/15/96
9:25
Nortel Communication Server 1000
Fiber Remote Multi-IPE Interface Fundamentals
NN43021-556 03.01
11 May 2009
Remote IPE fault isolation and correction 135
--End--
Login command
Type in the password.