Nortel Communication Server 1000 Series Manual page 17

Table 3
Equipment required to link local system to Remote IPE sites (cont'd.)
Component
Remote Fiber
Remote Multi-IPE
Interface Cable
Maintenance
Interface Cable
AC/DC Power
Converter
DC Power Cable
Attenuated Fiber
Loopback Cable
NT7R66AA SDI
Cable Kit
NT7R66BA MMI
Cable
NT8D46AL
System Monitor
daisy-chain cable
(Similar cable ma
y be purchased
in any telephone
equipment shop).
NT8D46AP
System Monitor
Serial Link Cable
Copyright © 2007-2009 Nortel Networks
.
Description
A 30-foot shielded cable connects the Remote IPE I/O
panel 24-pin Centronics connector to a Fiber Remote
Multi-IPE Interface unit SUPERLOOP 37-pin D Shell
connector.
A 2-foot DB-9 male to DB-9 female cable daisy-chains
multiple co-located Fiber Remote Multi-IPE Interface units
to share a common maintenance terminal. The male cable
connector plugs into the SDI connector and the female
cable connector plugs into the MAINT connector in the I/O
panel at the rear of the Fiber Remote Multi-IPE Interface
units.
A wall-mounted -48 Volt DC power converter with a 25-foot
power cable is provided with each Fiber Remote Multi-IPE
Interface unit.
DC 25-foot power cable that is connected between a -48
V system power source and the Fiber Remote Multi-IPE
Interface unit.
Fiber-optic cable used to loopback at the ST fiber-optic
connectors on the faceplate.
This cable kit provides a 10-foot DB-9 male to DB-25 male
cable and a DB-25F/DB-25F compact adapter. To connect
the standard SDI card to the DB-9 female SDI connector
of the Fiber Remote Multi-IPE Interface unit, use the cable
but not the DB-25F/DB-25F adapter. To connect the SDI
Paddleboard use the entire kit including the adapter. This
kit is used together with the NT8D93AJ cable for the
Paddleboard.
This is a 32-foot DB-9 female to DB-25 male cable.
Connect the MMI terminal to the DB-9 male MAINT port on
the Fiber Remote Multi-IPE Interface unit.
Connects RJ11 connectors XSM IN and XSM OUT
daisy-chaining Fiber Remote Multi-IPE Interface units. This
RJ11 phone cable has reverse leads: Black (2), Red (3),
Green (4), Yellow(5) at one end of the cable and Yellow
(2), Green (3), Red (4), Black (5) at the other end of the
cable.
Connects the 6-pin modular jack J5 on the Fiber Remote
Multi-IPE I/O panel to the system monitor jack J6 in the
pedestal.
Nortel Communication Server 1000
Fiber Remote Multi-IPE Interface Fundamentals
NN43021-556 03.01
11 May 2009
System description 17