Nortel Communication Server 1000 Series Manual page 144

144 Remote IPE maintenance
11
12
13
Removing and replacing a Peripheral Controller card
To remove and replace a Peripheral Controller card, follow the steps in
Procedure 48 "Removing and replacing a Peripheral Controller card" (page
144).
Procedure 48
Removing and replacing a Peripheral Controller card
Step
1
2
3
4
5
6
Copyright © 2007-2009 Nortel Networks
.
If the red LED flashes three times and stays on, it has passed
the test. Go to step 12.
If the red LED does not flash three times and then stays on,
it has failed the test. Pull the card partially out of the module
and reinsert it firmly into the module. If the problem persists,
troubleshoot or replace the Superloop Network card.
Connect the I/O panel cables to the J1 and J2 faceplate
connectors of Superloop Network card.
Set the ENL/DIS switch to ENL.
If the red LED on the Superloop Network card faceplate turns
off, the card is functioning correctly and is enabled. The outcome
of the self-test is also indicated on the system terminal or TTY
(or the MMI terminal connected to the Fiber Remote Multi-IPE
Interface MAINT connector). If the LED stays on, go to
and correcting faults" (page 124)
Tag the defective card(s) with a description of the problem and
prepare them for shipment to the equipment supplier's repair
depot.
Action
Log in on the TTY or the MMI maintenance terminal.
At the > prompt, type LD 32 and press the Enter key to access
the program.
Type DSXP x, where x is the Peripheral Controller card, and
press the Enter key to disable the card.
The Peripheral Controller card is now disabled and can be
removed.
Unlatch the card's locking devices by squeezing the tabs and
pulling the upper and lower locking devices away from the card.
Pull the card out of the Remote IPE module and place it in an
antistatic bag away from the work area.
Hold the replacement card by the card locking devices and insert
it partially into the card guides in the module.
Nortel Communication Server 1000
Fiber Remote Multi-IPE Interface Fundamentals
NN43021-556 03.01
11 May 2009
in this document.
--End--
"Isolating