Leaving Program Mode; Starting And Stopping The Centrifuge; Starting The Centrifuge; The "Stop" Key - Hermle Z 216 M User Manual

Table of Contents

2.5.3 Leaving Program Mode

To leave the program mode, press the key, "prog" (11). Then, inside the display "time", appears the

word "programm".

Set the display to "programm--" (M10) with the adjustable knob (1).

For all number marked text, please refer to Figure 25.

Start the centrifuge with either the "start" key (9), or the "quick" key (8).

With the "start" key (9), stored runs or runs with manually pre-selected parameters can be started.

When the respective pre-selected running time has ended, the centrifuge will stop automatically.

With the "quick" key (8), start runs, which will last a few seconds, can be initiated.

By pressing the "quick" key (8), the centrifuge accelerates up to the pre-selected revolution.

In the display "time" (A-3), the passed running time is indicated from the moment the "quick" key (8)

is pressed.

By releasing the "quick" key (8), the centrifuge stops and the running time is indicated, until the lid is

opened.

For all number marked text, please refer to Figure 24

Figure 24

With the "stop" key (10), the run time can be interrupted, at any time, (see Figure 25). After pressing

the key, the centrifuge decelerates with the respective pre-selected intensity, down to a standstill.

Figure 25

Z216M_V2.21_eng

OPERATION

Table of Contents