Recall Of Stored Programs; Leaving Program Mode; Starting And Stopping The Centrifuge; Starting The Centrifuge - Hermle Z 207 A Operating Manual

2.6.2 Recall of Stored Programs

To recall stored programs, press the key "prog" (11), with the lid already closed. Inside the display
"time" (A-3), appears "programm --"(M10). With the control field (1), pre-select the desired program
number. In the respective displays, the stored values, for that program, will appear.
Figure 18

2.6.3 Leaving Program Mode

To leave the program mode, press the key, "prog" (11). Then, inside the display "time", appears the
word "programm".
Set the display to "programm--" (M10) with the control field (1).
For all number marked text, please refer to Figure 18.

2.7 Starting and Stopping the Centrifuge

2.7.1 Starting the Centrifuge

Start the centrifuge with either the "start" key (9), or the "quick" key (8).
With the "start" key (9), stored runs or runs with manually pre-selected parameters can be started.
When the respective pre-selected running time has ended, the centrifuge will stop automatically.
With the "quick" key (8), start runs, which will last a few seconds, can be initiated.
By pressing the "quick" key (8), the centrifuge accelerates up to the pre-selected revolution.
In the display "time" (A-3), the passed running time is indicated from the moment the "quick" key (8)
is pressed.
By releasing the "quick" key (8), the centrifuge stops and the running time is indicated, until the lid is
opened.
For all number marked text, please refer to Figure 19.
© Hermle Labortechnik GmbH
Z207A_V1.17
_eng
OPERATING
17