Leaving Program Mode; Starting The Centrifuge; The "Stop" Key - Hermle Z 207 MK User Manual

2.5.3 Leaving Program Mode

To leave the program mode, press the key, "prog" (11). Then, inside the display "time", appears the
word "programm".
Set the display to "programm--" (M10) with the control field (1).
For all number marked text, please refer to Figure 28.

2.5.4 Starting the Centrifuge

Start the centrifuge with either the "start" key (9), or the "quick" key (8).
With the "start" key (9), stored runs or runs with manually pre-selected parameters can be started.
When the respective pre-selected running time has ended, the centrifuge will stop automatically.
With the "quick" key (8), start runs, which will last a few seconds, can be initiated.
By pressing the "quick" key (8), the centrifuge accelerates up to the pre-selected revolution.
In the display "time" (A-3), the passed running time is indicated from the moment the "quick" key (8)
is pressed.
By releasing the "quick" key (8), the centrifuge stops and the running time is indicated, until the lid is
opened. (See Figure 27).
Figure 27

2.5.5 The "STOP" Key

With the "stop" key (10), the run time can be interrupted, at any time, (see Figure 28). After pressing
the key, the centrifuge decelerates with the respective pre-selected intensity, down to a standstill.
Figure 28
© Hermle Labortechnik GmbH Z207MK_V1.21_eng
OPERATION
21