Figure 24
2.5.3 Leaving Program Mode
To leave the program mode, press the key, "prog" (11). Then, inside the display "time", appears the
word "programm".
Set the display to "programm--" (M10) with the adjustable knob (1).
For all number marked text, please refer to Figure 23.
2.6 Starting and Stopping the Centrifuge
2.6.1 Starting the Centrifuge
Start the centrifuge with either the "start" key (9), or the "quick" key (8).
With the "start" key (9), stored runs or runs with manually pre-selected parameters can be started.
When the respective pre-selected running time has ended, the centrifuge will stop automatically.
With the "quick" key (8), start runs, which will last a few seconds, can be initiated.
By pressing the "quick" key (8), the centrifuge accelerates up to the pre-selected revolution.
In the display "time" (A-3), the passed running time is indicated from the moment the "quick" key (8)
is pressed.
By releasing the "quick" key (8), the centrifuge stops and the running time is indicated, until the lid is
opened.
For all number marked text, please refer to Figure 25.
Figure 25
© Hermle Labortechnik GmbH
Z366_V1.18_eng
OPERATION
21