Leaving Program Mode; Starting And Stopping The Centrifuge; Starting The Centrifuge; The "Stop" Key - Hermle ZK 496 User Manual

Table of Contents

OPERATION

2.5.3 Leaving Program Mode

To leave the program mode, press the key "prog" (11). Then inside the display "time" appears the

word "programm".

Set the display to "programm-" (M10) with the adjustable knob (1).

For all number marked text please refer to Figure 29.

Start the centrifuge with either the "start" key (9) or the "quick" key (8).

With the "start" key (9) stored runs or runs with manually pre-selected parameters can be started.

When the respective pre-selected running time has ended, the centrifuge will stop automatically.

With the "quick" key (8) start runs, which will last a few seconds, can be initiated.

By pressing the "quick" key (8), the centrifuge accelerates up to the pre-selected revolution.

In the display "time" (A-3) the passed running time is indicated from the moment the "quick" key (8)

is pressed.

By releasing the "quick" key (8) the centrifuge stops and the running time is indicated until the lid is

opened.

The "quick" key (8) cannot be used during program operation.

For all number marked text please refer to Figure 30.

Figure 30

With the "stop" key (10) the run time can be interrupted at any time (see Figure 31). After pressing

the key, the centrifuge decelerates with the respective pre-selected intensity down to a standstill.

Figure 31

ZK496_V1.22_eng

Table of Contents