Recall Of Stored Programs; Leaving Program Mode - Hermle Z 366 K User Manual

2.5.2 Recall of Stored Programs

To recall stored programs, press the key "prog" (11), with the lid already closed. Inside the display
"time" (A-3), appears "programm --"(M10). With the adjustable knob (1), pre-select the desired
program number.
In the respective displays, the stored values, for that program, will appear.
If there is not the correct rotor inside the centrifuge, for the pre-selected program, in the display
"rpm/rcf" (A-1) flashes the word "rotor" (M3). At the same time, the word "FALSE" and the stored
rotor number "22x. xx""(M4) flash in sequence of one another.
For all number marked text, please refer to Figure 27.
Figure 27

2.5.3 Leaving Program Mode

To leave the program mode, press the key, "prog" (11). Then, inside the display "time", appears the
word "programm".
Set the display to "programm--" (M10) with the adjustable knob (1).
For all number marked text, please refer to Figure 27.
© Hermle Labortechnik GmbH Z366K_V1.22_eng
OPERATION
27