Leaving Program Mode; Starting And Stopping The Centrifuge; Starting The Centrifuge; Stopping The Centrifuge - Hermle Sieva-3 Instruction Manual

Filtration centrifuge

Table of Contents

4.4.3 Leaving Program Mode

To leave the program mode, press the key, "prog" (11). Then, inside the display "time", appears the

word "programm".

Set the display to "programm--" (M10) with the control field (1).

For all number marked text, please refer to Figure 20.

Start the centrifuge with either the "start" key (9), or the "quick" key (8). With the "start" key (9),

stored runs or runs with manually pre-selected parameters can be started. During the centrifugation

the LED light is flashing slowly with red color. When the respective pre-selected running time has

ended, the centrifuge will stop automatically.

By pressing the "quick" key (8), the centrifuge accelerates up to the pre-selected revolution. In the

display "time" (A-3), the passed running time is indicated from the moment the "quick" key (8) is

pressed. By releasing the "quick" key (8), the centrifuge stops and the running time is indicated, until

the lid is opened.

For all number marked text, please refer to Figure 21.

Figure 21

With the "stop" key (10), the run time can be interrupted, at any time, (see Figure 22). After pressing

the key, the centrifuge decelerates with the respective pre-selected intensity, down to a standstill.

After the centrifugation is finished, the LED lights with green color.

Figure 22

Sieva-3_V1.18_dt

OPERATION

Table of Contents